Product Type:
Rectified Glazed Porcelain
Digital Print Technology
PRODUCT CONTAINS
≥20% PRE-CONSUMER
RECYCLED CONTENT
Product Type:
Rectified Glazed Porcelain
Digital Print Technology
PRODUCT CONTAINS
≥20% PRE-CONSUMER
RECYCLED CONTENT
Stocked Colors:
Themar Bianco Lasa
Themar Crema Marfil
Themar Grigio Savoia
Themar Statuario V
Themar Venato Gold
Stocked Finishes:
Matte
Polished
Stocked Sizes:
3 x 12
12 x 24
24 x 24
2 x 2 Mosaic Mesh
(0.9588 sf/sht)
2-3/8 x 2-3/8 Hex Mesh
(0.72 sf/sht)
Stocked Trims:
1/2 x 11-5/8 Pencil Bullnose
3 × 12 Surface Bullnose
Recommended Uses:
Commercial
Residential
Interior Floor
Interior Wall
Exterior Cladding
Fireplaces
Shower Walls
*Shower Floors
Steam Showers
Pool & Spa
*Matte 2 x 2 Mosaic Mesh and
Hex 2-3/8 Mesh Only
DCOF Rating (See Tech Specs Tab) is a measurement of a tiles frictional resistance. It is the specifier’s responsibility to ensure the chosen tile is appropriate for each interior and exterior application.
The Themar Series is a rectified glazed porcelain. Digital print technology creates some of the same characteristics as some of the most sought-after natural stones, including marble. Because this material is a porcelain product, maintenance risks involved with actual stone are eliminated. There will be noticeable variations in color and movement between pieces. Therefore, it is important and recommended that a range of this product be viewed before finalizing a purchase.
Piece to piece variation in shade or color are inherent in all fired clay products; therefore, it is recommended to mix tiles from several boxes at a time during installation to achieve the best range of color. This series is suitable for residential and commercial applications.
Grout release is recommended for the polished finish, prior to grouting so grout powders do not fill pores in the tile surface, which can attract dirt when walked upon. It is recommended to use a coordinating grout color for all polished porcelain, contrasting grout colors are not recommended. For proper bonding, LHT/LFT mortar for large format and heavy tiles should be used when installing tiles with a dimensional length greater than 15 inches and rectangular shape and plank tile, per industry standards. Proper thinset coverage is also necessary, and in some cases, back buttering of tile may be required.
TECHNICAL CHARACTERISTICS | NORM | EXPECTED LIMIT VALUES | TYPICAL VALUE |
---|---|---|---|
DYNAMIC COEFFICIENT OF FRICTION | ANSI A137.1:2012 | DYNAMIC WET ≥ 0.42 | DYNAMIC WET MATTE ≥ 0.42 DYNAMIC WET POL. N/A |
VISIBLE ABRASION RESISTANCE | UNI EN ISO 10545-06 | REQUIRED | RESISTANT |
CHEMICAL RESISTANCE | UNI EN ISO 10545-13 | REQUIRED | RESISTANT |
FROST RESISTANCE | UNI EN ISO 10545-12 | REQUIRED | RESISTANT |
WATER ABSORPTION | UNI EN ISO 10545-03 | ≤ 0.5% | ≤ 0.1% |
BREAKING STRENGTH | UNI EN ISO 10545-04 | S ≥ 1300 N R ≥ 35 N/mm² | S COMPLIANT > 40 N/mm² |
DCOF rating is a measurement of a tile’s frictional resistance. It is the specifier’s responsibility to ensure the chosen tile is appropriate for each interior and exterior application.
P.E.I. RATING: 4